Women’s Warm and Waterproof Ski Jacket 500

This product is repairable. We commit to repairing your product free of charge for the duration of the warranty. Whatever it is, fixings, seams, zips, etc. This service is offered in your usual store. However, if we can\'t repair your product (production defect), we will exchange it or reimburse you.

Bear in mind that the water-repellent feature can be reactivated. To do this, you can use a waterproof spray (sold in our stores): spray the product evenly over the entire garment, then leave it to dry for 10 to 12 hours).

This garment wicks away the water vapour produced by your body when exercising. To see if a fabric is breathable, its resistance to evaporative heat (RET) is measured in a standardised ISO 11092 test. The lower the RET, the more breathable the fabric. The jacket 500 has an RET of 11. However, it is the technical solutions (zips, vents, mesh) that Wedze uses, which reduce the condensation inside the garment and maximise breathability.

In addition to its filling, your jacket\'s waterproof zips, snow skirt, collar and adjustable hood and cuffs offer better protection against the cold for a warmer feeling.

Dry in a tumble dryer (strongly recommended) * Use a gentle or delicate programme. * Dry on several long cycles to dry completely. * If you do not have a tumble dryer, it will take longer to dry. (drying can take 1 to 2 weeks on a dry and flat place). Make sure you pat the jacket to avoid any lumps

Slim fit. The jacket has sides that fall straight and remain parallel rather than trying to follow the shape of your body. The interior volume means this jacket can be worn in combination with a first and second technical layer.

To make sure you stay warm and dry, we recommend using the 3-technical-layer rule: - Layer 1 or a second skin, to stay dry. - Layer 2 or an insulating layer, to keep the heat in. - Layer 3 or a protective layer to protect against the elements.

The resistance of a fabric is measured by the height of a water column in mm that can be supported by the fabric (test based on the ISO 811 standard). The higher the pressure, the more waterproof the fabric. A component with a water resistance of 8000mm therefore withstands the pressure exerted by 8000mm of water.

The snow skirt (which is automatic), as well as the adjustable cuffs, prevent the entry of snow and air during practice and especially in case of a fall.

The membrane is a very fine component applied to the inner surface of the outer jacket fabric. This hydrophilic component prevents water from seeping in while wicking away the perspiration produced by the body. The membrane is unbeatable when it comes to staying warm and dry.

The model is wearing size M and is 1.73 m tall Their measurements are as follows: - Chest circumference 85cm Arm length 57cm (from shoulder bone to wrist) - Waist circumference 67cm Inside leg 83cm - Hips 99cm

The 500 jacket has been developed with a rigorous component and assembly, which block the passage of water and limit the wind chill factor so that you can better cope with bad weather (rain, snow, wind, etc.). To validate its waterproof rating, this jacket was tested under a special shower that replicates the conditions skiers have to face. We validated the waterproofing of this product in the field in various weather conditions for several days.

The water-repellent property of a fabric is its capacity to allow water to run off its surface without seeping in. This jacket features water-repellent components that extend its weather resistance. The fabric is made water-repellent by treating its outer surface. However, this property may deteriorate with use.

* Close all the zips on the jacket * Turn it inside out * Machine wash at 30°, delicate programme with little detergent & without fabric softener. IMPORTANT: set to a very gently spin cycle (less than 800 rev/min): spinning too fast may create lumps that are difficult to remove